S200: Safety Precautions

WARNING: READ these instructions before connecting power. Damage can result from MISWIRING at the power terminals. DANGEROUS voltages are present on power input and motor output terminals.

Only qualified personnel are permitted to transport, assemble, commission, and maintain this equipment. Properly qualified personnel are persons who are familiar with the transport, assembly, installation, commissioning and operation of motors, and who have the appropriate qualifications for their jobs.

Read all available documentation before assembling and using the drive. Incorrect handling of products can result in injury and damage to people and/or machinery. Strictly adhere to the technical information regarding installation requirements.

Keep all covers and cabinet doors shut during operation.
Be aware that during operation, the product has electrically charged components and hot surfaces. Control and power cables can carry a high voltage, even when the motor is not rotating.
Never disconnect or connect the product while the power source is energized.
After removing the power source from the equipment, wait at least 5 minutes before touching or disconnecting sections of the equipment that normally carry electrical charges (e.g., capacitors, contacts, screw connections). To be safe, measure the electrical contact points to each other and to electrical safety earth with a meter before touching the equipment.

Unpacking and Inspecting

Open the box and remove all the contents. Check to ensure that there is no visible damage to any of the equipment.

WARNING: Use proper procedures when handling electronic components to avoid damage to equipment. Remove all packing material and equipment from the shipping container. Be aware that some connector kits and other equipment pieces may be quite small and can be accidentally discarded. Do not dispose of shipping materials until the packing list has been checked.

Upon receipt of the equipment, inspect components to ensure that no damage has occurred during the shipment. If damage is detected, notify the carrier immediately. Check all shipping material for connector kits, documentation or other small pieces of equipment.

Previous | Next