Select a Step ......................................................... Safety Warnings Install MDK Software Install Controller Connect Hardware Motion Console - Download Controller Firmware - Add New Controller - Check Network Information - Check Node Information - Download Node FPGAs - Check Node Configuration - Map the Axes - Tune the Servo Control Loop - Move a Motor - Microsoft Visual C/C++

Quick Start Guide QMP-SynqNet Controller

Motion Console

Check Network Information

After the proper firmware has been downloaded for the controller, check the Network Information to verify that the proper number of blocks were found. Click on the button to open the SynqNet Summary Window. Under the Info tab, the value for node count is 1 since the SynqNet Network that was used for this example had one RMB-10V2 installed.

A node refers to any SynqNet node, such as a SynqNet Drive or an RMB-10V2 (for analog) that is installed on a SynqNet network.