Release Note
Motion Scope

Description:
User can now select and reuse existing inactive Recorders upon Pane creation.

Description:
Traces have been added for digital and analog inputs/outputs.
There are I/O from several sources:
    - Motor
    - Node
    - Controller
    - CAN

Description:
In earlier versions, in order to add a drive monitor field, a customer had to use VM3 and find out what address to use. Three drive monitor fields have been added in the list of selectable common traces.

Description:
Motion Scope is crippled by recorder triggers.

Description:
Motion Scope, in the Pane shutdown procedure, now stops the Recorder before deleting it.
As a result, MPI memory is released.

Description:
Motion Scope will sometimes hang when opening a .PAN file. This can be recreated by opening a .PAN file and then closing the pane. Repeat until the hang occurs--usually after the 4th or 5th time.

Description:
When collecting/displaying data, sometimes the data points do not align properly with the scale markers on the X axis. This is easiest to see by turning on the "sample band" in the Pane Display configuration and Displaying in Units of Samples. The problem can be corrected by forcing a re-draw of the data: sliding the data on/off the screen, minimizing/maximizing, or zooming in/out.

Description:
The restriction of max one Pane per Controller has been removed, so that Traces from the same Controller may be displayed independently in different window Panes.

Description:
Display the current X and Y coordinates of the cursor in the pane on the status bar. This would make it easier to select a very accurate zoom area.In addition, Status Bar will be turned on if this display is selected (via the Pane Display dialog). Status Bar viewing is saved in the Initialization file.

Description:
The following problem was reported using MPI 20021219 and has been fixed in Motion Scope version 1.21.15:

1. Open Motion Scope, and configure it to record a measured position, then capture some data. See the first screen shot in the attached file.
2. Save the Motion Scope pane using File -> Save As.
3. Close the view using File -> Close.
4. Load the previously saved pane using File -> Open.

The time axis is now the same in both cases, as would be expected.

Description:
Motion Scope will report a "printer error" if no printer is configured when asked to print.

Description:

Description:
Upon Pane creation, if the MPI thinks there are no more Recorders available, Motion Scope will pop up a dialog box asking the user for a new Recorder number to use, and the number of records to allocate for the new Recorder. A list of current recorders and records used is shown in the dialog, as well as the available memory and records for use by the new Recorder. Upon Pane destruction, the newly allocated Recorder will be deleted from the Mpi Configuration.

Description:
The MPI data Recorder is re-Configed everytime the Motion Scope Go/Arm button is pressed, effectively clearing the MPI Recorder internal data buffer, which had been causing "strange gaps" to appear in Motion Scope data.