|
Saving to Flash Table
It is important to know what is saved and what is not
saved when you save an object in Motion Console. The table below summarizes
what is actually saved when you use the Save to Flash feature.
NOTE: The mappings of objects to sub-objects
are saved (ex: Motion Supervisor axes mappings), except in the case of
SynqNet-to-Nodes-to-(I/O and Motors) and CAN-to-nodes-to-I/O.
|
Object
|
Saved
|
Not Saved
|
Notes
|
| Controller |
Config tab,
Recorders tab,
Axis Map |
Action tab,
Version tab,
Stats tab |
|
| Motion Supervisor |
Stop Time,
E-Stop Time,
Normal Feedrate,
Axis Map |
Everything Else |
|
| Axis |
Config tab,
|
Motion tab,
Status tab |
|
| Filter |
Config tab,
Coeff tab
|
|
Post filters are saved, but are not shown in Motion
Console. |
| Motor |
Config tab
(except Amp Enable),
Events tab,
SinCom tab,
Upper I/O tab |
Amp Enable,
Home Trigger,
Encoder Fault Trig.,
Status tab,
(Lower) I/O tab
|
|
| SynqNet |
|
Config tab,
Info tab,
Status tab,
Axis Map (Save with SynqNet topology) |
|
| SynqNet Node |
Config tab
(except Upstream Err. Fault/Fail Limits) |
Upstream Err. Fault Limit,
Upstream Err. Fail Limit,
Info tab |
|
| CAN |
Config tab |
|
|
| CAN Node |
Config tab |
|
|
| I/O |
Motor I/O tab
(Type only, not Out or In) |
SqNode I/O tab,
Motor I/O tab - Out and In,
CAN I/O tab
|
|
Previous | Next
|
