After the proper firmware has been downloaded for the
controller, check the Network Information to make sure that the proper
number of blocks were found. Click on the
button to open the SynqNet Summary Window. Under the Info tab, it shows
1 node since the SynqNet Network that was used for this example had one
RMB-10V2 installed.
A node refers to any SynqNet node, such as a SynqNet
Drive or an RMB-10V2 (for analog) that is installed on a SynqNet network.
button to open the SynqNet Summary Window. Under the Info tab, it shows
1 node since the SynqNet Network that was used for this example had one
RMB-10V2 installed.