.

Ethernet LEDs

The Ethernet port has two LEDs: Link/Act and 10/100. The Link/Act LED should be ON at each end of the Ethernet cable. If the Link/Act LED is not ON, it usually indicates that there is a bad connection or a bad cable. See the table below for the meaning of each LED and its state.

LED State Table: Ethernet
LED
Meaning
State
Link/Act
Link Activity
ON = link active
BLINK = network activity
OFF = link inactive
10/100
Baud Rate / Network Speed
ON = 100Mb
OFF = 10Mb

 

       Legal Notice  |  Tech Email  |  Feedback
      
Copyright ©
2001-2010 Motion Engineering