Select a Step ......................................................... Safety Warnings Introduction Hardware Setup Host-side Configuration Changing Network Interface Parameters Using the eXMP-SynqNet Motion Controller

eXMP-SynqNet QS Guide Linux

Using the eXMP-SynqNet Motion Controller

By default, the standard Linux XMP device driver ('/mei/Release/meixmp.o') is loaded during startup. This is an MPI version-independent file.

To execute any XMP utilities or applications, load executable file to the eXMP via ftp, and execute them from a console or telnet shell.

NOTE: As with any UNIX based system, you will need to set the attributes of any file you ftp to the eXMP-SynqNet. This can be done using the chmod command. Please consult your UNIX documentation for more information on using this command.

Congratulations! You have successfully configured the eXMP-SynqNet for console mode using Linux. The eXMP-SynqNet is now ready for testing and development.

Previous | Back to Table of Contents