Select a Step ......................................................... Safety Warnings Install MDK (software) Install Controller Connect Hardware Motion Console - Download Controller Firmware - Add New Controller - Check Network Information - Check Node Information - Download Node FPGAs - Check Node Configuration - Map the Axes - Tune the Servo Control Loop - Move a Motor! - Microsoft Visual C/C++

Quick Start Guide XMP-SynqNet Controller

Motion Console

Check Network Information

After the proper firmware has been downloaded for the controller, check the Network Information to make sure that the proper number of nodes were found. Click on the button to open the SynqNet Summary Window. Under the Info tab, it shows 1 node since the SynqNet Network that was used for this example had one RMB-10V installed.

A node refers to any SynqNet node, such as a SynqNet Drive or an RMB-10V (for analog) that is installed on a SynqNet network.